INA 6205-C-C3 1 Row Ball Bearing - 25 mm ID, 52 mm OD

High and very high speeds are requiredThe bearing arrangement must be operated with very low frictionVery low running noise is required, without reducing the speed, load carrying capacity and operating life of the bearing (Generation C)High demands are made on the sealing of the bearing, without increasing heat generation or limiting the speed (Generation C)The bearing position is to be designed particularly economicallyDouble row bearings can be considered for bearing arrangements where:The load carrying capacity of single row deep groove ball bearings is no longer sufficientAxial loads in both directions and/or tilting moments must be supported in addition to radial loadsA high load carrying capacity is required and the design envelope available in a radial and axial direction is relatively small

High and very high speeds are required

The bearing arrangement must be operated with very low friction

The bearing arrangement must be operated with very low friction

Very low running noise is required, without reducing the speed, load carrying capacity and operating life of the bearing (Generation C)

Very low running noise is required, without reducing the speed, load carrying capacity and operating life of the bearing (Generation C)

High demands are made on the sealing of the bearing, without increasing heat generation or limiting the speed (Generation C)

High demands are made on the sealing of the bearing, without increasing heat generation or limiting the speed (Generation C)

The bearing position is to be designed particularly economically

The bearing position is to be designed particularly economically

Double row bearings can be considered for bearing arrangements where:

Double row bearings can be considered for bearing arrangements where:

The load carrying capacity of single row deep groove ball bearings is no longer sufficient

The load carrying capacity of single row deep groove ball bearings is no longer sufficient

Axial loads in both directions and/or tilting moments must be supported in addition to radial loads

Axial loads in both directions and/or tilting moments must be supported in addition to radial loads

A high load carrying capacity is required and the design envelope available in a radial and axial direction is relatively small

A high load carrying capacity is required and the design envelope available in a radial and axial direction is relatively small