INA NJ210-E-XL-TVP2 50 mm ID Roller Bearing, 90 mm OD

Bearing arrangements are subjected to very high radial loadsNot only high radial forces but also axial loads from one or both directions must be supported by the bearing position (semi-locating or locating bearing function)Bearing arrangements must have very high rigidityAxial displacements of the shaft relative to the housing must be compensated without constraint in the bearing (in the case of bearings with a non-locating or semi-locating bearing function)High radial loads and very high speeds occur but the very high radial load carrying capacity of full complement cylindrical roller bearings is not requiredThe bearings should be separable (one bearing ring can be removed) for easier mounting

Bearing arrangements are subjected to very high radial loads

Not only high radial forces but also axial loads from one or both directions must be supported by the bearing position (semi-locating or locating bearing function)

Not only high radial forces but also axial loads from one or both directions must be supported by the bearing position (semi-locating or locating bearing function)

Bearing arrangements must have very high rigidity

Bearing arrangements must have very high rigidity

Axial displacements of the shaft relative to the housing must be compensated without constraint in the bearing (in the case of bearings with a non-locating or semi-locating bearing function)

Axial displacements of the shaft relative to the housing must be compensated without constraint in the bearing (in the case of bearings with a non-locating or semi-locating bearing function)

High radial loads and very high speeds occur but the very high radial load carrying capacity of full complement cylindrical roller bearings is not required

High radial loads and very high speeds occur but the very high radial load carrying capacity of full complement cylindrical roller bearings is not required

The bearings should be separable (one bearing ring can be removed) for easier mounting

The bearings should be separable (one bearing ring can be removed) for easier mounting