EUD61M-UC, multifunction universal dimming switch, power MOSFET up to 400W

Additionally available packaging sizes: 1 / 10 / 100

Universal dim switch. Power MOSFET to 400W. Automatic lamp recognition. Stand-by loss only 0.1 watts. Minimum brightness adjustable. With children's room and slumber. For installation. 45mm long, 45mm wide, 18mm deep. Universal dimming switch for lamps up to 400W, depending on the ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps in addition to the lamp electronics. Zero-pass circuit with soft-on and soft-off for lamp protection. Universal control voltage 8.. 230V UC, galvanically separated from the supply and switching voltage 230V. Short control commands turn on / off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the direction of dimming. The set brightness level is stored when the memory functions are switched off. In the on-maxs functions is always switched on with maximum brightness level. In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. Automatic electronic overload protection and overtemperature shutdown. With the upper% lamp switch, the minimum brightness can be set (fully dimmed), e.g. for dimmable energy-saving lamps. The automatic operation allows the dimming of all lamp types. The lower function switch can be used to select between five automatic operating functions: memory, memory + soft on, on max, on max + soft on and ESV + soft on. + ESL is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to the design, so that they also turn on in a cold way. -ESL is a comfort position for energy-saving lamps, which cannot be switched on again in accordance with the design. So memory is turned off in this position. In the positions + ESL and -ESL no inductive (wrapped) trafos may be used. In addition, the maximum number of dimmable energy-saving lamps may be less in design than in automatic operation. ESV function setting like memory + soft on with a drop-back delay at% lamp switch up to 90 minutes if not manually switched off. At the end off warning by dipping within 1 minute. With children's room: When switching on with longer button actuation, after approx. 1 second with the smallest brightness and, as long as it is further checked, slowly dimmed up without changing the last saved brightness level. With slumber: By means of a double pulse, the lighting is dimmed and switched off from the current dimming position to the minimum brightness. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. Short keys can be switched off at any time during the dipping process. A long key dims high during the dipping process and ends the slumber. L-loads (inductive loads, e.g. wrapped transformers) and C-loads (capacitive loads, e.g. electronic transformers) shall not be mixed. R- loads (ohmic loads, e.g. 230V filament and halogen lamps) can be mixed as required.