540500, S3000 electric. Gear. Use

S3000 electric. Gear. Use

System 3000 Electronic switching - connection of remote points possible. - Control of thermal actuators in combination with a room temperature control kit. - Lamp-gentle on. - Electronic short circuit protection. - Electronic overtemperature protection. - operation with and without a neutral line connection. - switching of filament lamps, HV halogen lamps, electronic or inductive trafos with halogen or LED lamps, switched or dimmable HV LED or compact fluorescent lamps. - The device is supplied via the external ladder and the neutral ladder so no phase cut or phase section is made. - switching of filament lamps, HV halogen lamps, electronic or inductive trafos with halogen or LED lamps, dimmable HV LED or compact fluorescent lamps. - The equipment is supplied by the external conductor and the connected load and therefore works in the phase or phase cutting principle. - Automatic or manual setting of the dim principle appropriate to the load (phase or phase). - display of the set mode by LED. Combination with RF operating kit 1-fold / 2-fold for KNX: - switch-actuator channel 1-fold or heating unit 1-fold. - Sensor channel 1-fold or 2-fold. - Local control of the system 3000 use possible. - Radio control of other devices for KNX as a sensor possible. - Temperature recording: It shall be ensured that the connected loads do not exceed 40 W. - {b} the function selection of the use for switches: {\ b} closing / opening operation, stairway function with a stop warning, scene function (16 scenes), blocking function, time delays. Remote input as additional control for the system 3000 use or for radio control of other devices for KNX as sensor. - {b) the choice of function of the use for room temperature control: {\ b} the control of 230 V actuators, heating, cooling, heating and cooling, switching of the heating or cooling operation by means of communication object or remote input. PWM and 2-point controller, absolute and relative set value, heat control including Cascading, valve protection function. Cyclic monitoring of floor temperature, service operation for valve output, frost protection function (automatic or via communication object), comparison of temperature sensor, boot function, summer and winter compensation, scene function (16 scenes). Remote input as additional control for the system 3000 use or for radio control of other devices for KNX as sensor. Alternatively, the remote input can be parametrized to switch between the heating and cooling operation. - Care must be taken to ensure that the connected loads do not exceed 40 W if the electronic switching inastz acts as a room temperature regulator. - dimmable HV LED lamp required. The minimum load for filament lamps, HV halogen, Tronic trafos and wrapped trafos is increased to 50 W when operating without a new trafos. At a higher ambient temperature than 25 ° C, the connected load shall be reduced.