KTTSS 300, very heavy, 156x330 mm, 10.0 kN, steel, galvanized DIN EN ISO 1461

Clamp support, very heavy, 156x330 mm, 10.0 kN, steel, galvanized DIN EN ISO 1461

Clamp support, very heavy design, for wall mounting and for clamping on bare steel support with a flange width of = 100 mm to = 320 mm, required clamping accessories on T support, such as 2 x SKM 12x..., 2 x UGM 12 and 2 x HSKS..., please order separately. Please order the required mounting accessories for wide-range cable gutters / conductors separately. The clamp fastening should be symmetrical and the screws placed as close to the flange as possible. The load-capacity data shall only apply in conjunction with HSKS..., UGM 12 and screws M 12, strength class 10.9, which shall be applied with a prevoltage torque of 123 Nm. In the case of connections which have to transfer vertical loads over friction, it is essential to pay attention to the torque of the screw and to check with the torque key! The required load values apply only to steel-based connections (e.g. profile clamps). After the half load has been applied, the fitting torque of the screws shall be checked again. Danger of slipping! If steel support is fitted with a fire-proof paint, it shall not be removed without consultation and written release of the contractor or the construction line. In any case, the introduction of the loads into the building must be coordinated with the construction planning or construction management. Dimensions (approx.) mounting height H: 156 mm angle width B: 400 mm mounting length L: 330 mm load capacity F at L / 2: 10 kN in the system tested, applies to support flange width = 220 mm and = 300 mm. Load capacity F2 at L / 2: 10 kN in the system tested, applies to carrier flange widths = 220 mm material boom: steel, fire forks. according to DIN EN ISO 1461 flange thickness of the carrier in mm: [customer information required]