DHS 4-125 NA, Doepke load separation switch compact, 125 A, 4 S, with NOT-off function

Doepke load separation switch compact, 125 A, 4 S, with NOT-off function

The Main switches separate electrical consumers or plant parts completely and all-politely from the electrical supply. They also switch under load or overload. They are used to shut down maintenance and plant protection. The devices of the DHS 4 series are load separation and The main switch in four-pin version where the N- contact is switched on and switched off after. Due to their design, they are perfectly integrated into the look of the DFS. DHS with NOT-off function allow the connection of a NOT-off device, such as buttons. An integrated LED signals the trigger through a control element or by wire break. A reconnection will be prevented until it is corrected. Characteristics: with NOT-off function for triggering or Disconnection by means of control elements, monitoring of the NOT-off function on wire break and display by a LED, in the event of a voltage failure, the NOT-off function does not lead to any trigger, high short-circuit strength and high switching capacity, two-sided double-deck terminals for large wire cross-section and assembly rails, switching display, type of assembly: fast-fitting on the support rail, feed-in from the top, installation position of any kind, application areas: especially suitable for use in main distribution in wide-range power supplies, e.g. For example, for campsites, marina ports, small garden colonies, display sites, etc., information: according to EN 60947-3, load separation switches combine the function of a load switch which can switch a current (including a specified operating overload) under operating conditions, and also the function of a separation switch. which ensures a safe separation by a sufficient contact distance. The DHS 4 provides a FELV voltage for the emergency-off circle. For this reason, the emergency-off circle must be measured for a voltage of 230 VAC.