EUD61NP -230V, universal dimming switch, power MOSFET up to 400W

Universal dimming switch, power MOSFET up to 400W

Without N- connection, Power MOSFET up to 400W. Stand-by loss only 0.5 watts. With control inputs for light buttons and light switches. Minimum brightness and dimming speed adjustable. For installation. 45mm long, 45mm wide, 18mm deep. Universal dimming switch for R, L and C loads up to 400W depending on the ventilation behaviour. Automatic detection of the load R + L or R + C. For 230V LED lamps and energy-saving lamps ESL not suitable, please use EUD61NPL or the dimmer EUD61NPN with N- connection. Zero-pass circuit with soft-on and soft-off for lamp protection. Control voltage 230V. Minimum load 20W. Short control commands turn on / off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the direction of dimming. The set brightness level remains stored when switching off. In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. Automatic electronic overload protection and overtemperature shutdown. With the upper% lamp switch, the minimum brightness (fully dimmed) can be set. The dimming speed can be set with the lower dim speed switch. At the same time, the duration of soft-on and soft-off is changed. In the event that the light switch cannot be replaced by the light button, there is a separate control input for the light switch: If the closed switch is reopened for a short time, then it is dimmed until it is reopened for a short time. A change of the direction of the dimming is made automatically at the two main points. In addition, the direction can be changed by opening the switch twice for a short time. With children's room control (only when using a button): When switching on with a longer button operation, after ca.1 second is switched on with the smallest brightness and, as long as the button continues, slowly dimmed up without changing the last saved brightness level. With slumbering (only when using a button): By means of a double pulse, the lighting is dimmed and switched off from the current dimming position to the minimum brightness. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. Short keys can be switched off at any time during the dipping process. A long key dims high during the dipping process and ends the slumber. Without N- connection, therefore suitable for installation directly behind the light button or light switch, even if there is no N- line. L-loads (inductive loads, e.g. wrapped transformers) and C-loads (capacitive loads, e.g. electronic transformers) shall not be mixed. R- loads (ohmic loads, e.g. 230V filament and halogen lamps) can be mixed as required.