LECKMASTER 101 AC 230 V, switching unit, supply voltage AC 230 V, mounting on DIN rail 35 mm or mounting over 2 holes

Switching unit, supply voltage AC 230 V, mounting on DIN rail 35 mm or mounting over 2 holes

Switching device for U-rail assembly, supply voltage 230V AC / with general construction control approval Z-65.40-297 In combination with capacitive leak sensors. The device is intended only for the control cabinet installation or for the installation in a protective housing and may therefore only be installed there. It is only suitable for use in a clean environment. If the switch is switched on for the self-restraint, a once occurring alarm is stored. The relay continues to report alarm, even if the alarm ground, e.g. For example, the presence of oil or a broken line is no longer given, that is, if the sensor is no longer controlled or the line is in contact again. By turning off the switch for the self-restraint the alarm is then quitted. If the switch for the self-restraint is not switched on, the alarm is not held after the alarm is dropped, but then disappears again. Versspannung: AC 230 V / further supply voltages on request power consumption approx. 3 VA / control circuit (Cl. 6 and 8) 2 connections (lead protection small voltage SELV) / active circuit (Cl. 9, 10, 11) 1 single-pole potential-free changer in the rest current principle / switching voltage max. AC 250 V AC 4 A switching power max. 500 VA housing insulation material, 75 x 55 x 110 mm / protection type IP 20 Assembly quick fitting for U-rail according to DIN 46 277 and DIN EN 50 022 / installation position any temperature range? 20 ° C to + 60 ° C Max. The length of the connection line between the switch and the sensor 1000 m shall be taken into account by the appropriate technical data.