KRW12DX-UC, coupling relay, 1 closing 16A

Coupling relay, 1 close 16A

1 Closing potential-free 16A / 250V AC with tungsten lead contact. The forward contact closes before the main contact and thus manages a switching current of LED light sources over a few ms. Max. On-line power 500A / 2ms. 230V LED lamps up to 600W, light bulbs 3300W. No stand-by loss. Line installation device for assembly on DIN-EN 60715 TH35. 1 unit of division = 18mm wide, 58mm deep. The most modern hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. With the patented ELTAKO- Duplex technology (DX), the normally potential-free contacts can still switch 50Hz in the zero pass when switching 230V AC voltage and thus drastically reduce wear. For this purpose, simply connect the N- conductor to the terminal (N) and L to 1 (L). This results in a stand-by loss of only 0.1 watts. If the contact is used to control switching devices that do not even switch in the zero passage, (N) should not be connected, as the additional locking delay otherwise causes the opposite. Universal control voltage 12.. 230V UC. Low switching noise. Control display with light diode. By using a bistabile relay, there is also no coil loss and no heating. The relay contact may be open or closed at the time of commissioning and synchronized at the first operation. This relay is not suitable for feedback with the switching voltage of a dimming switch. Use only the ESR12DDX-UC, ESR12NP-230V + UC or ESR61NP-230V + UC relays. The electronics have no power supply and therefore no stand-by loss. Only when the control contact is closed is the microcontroller activated, which switches the bistabile relay in the right direction. When opening the control contact or falling control voltage is switched back.