TLZ61NP-230V, Stair light time switch, 1 close 10A

Stair light time switch, 1 close 10A

1 closing not potential-free 10A / 250V AC, 230V LED lamps up to 600W, ESL up to 200W, filament lamps up to 2000W. Disable warning and switch-off light. Stand-by loss only 0.7 watts. With ESL optimization. For installation. 45mm long, 45mm wide, 18mm deep. Contact in the zero passage for the protection of contacts and lamps. By using a bistabile relay, there is also no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. Control, supply and switching voltage 230V. Time setting 1 to 12 minutes. Mica flow rate up to 50mA, depending on the ignition voltage of the mica lamps. For 3 and 4-wire circuits, switchable, with roof lighting at 4-wire circuit. Automatic detection of the circuit type. After a power failure, the lighting is switched on again if the time course has not yet been completed. With the switch-off warning the lighting flashes approx. 30 seconds before the time run and a total of 3 times at shorter intervals. In the case of the switch-on light, keys can be placed for more than 1 second on permanent light, which is automatically switched off after 60 minutes or can be switched off with buttons for more than 2 seconds. When the switch-off light is switched on and the switch-off warning is switched on, the switch-off warning is first carried out after the switch-off of the continuous light. If energy-saving lamps ESL are switched in whole or in part, then set the switch-off warning with the active light ESL on the lower switch. Within the first second after switching on or after switching on the TLZ functions, the time can be extended by up to 3-times short buttons (pumps). Each key adds 1 times the set time. To the ESV function, current shock switch with relapse delay up to 120 minutes, switchable. This function will be automatically switched off after the adjustable delay time has expired if the manual output command has not been given. If the delay time is set to a minimum in the ESV function, the return delay is switched off and the normal current shock switch function ES results.