Fud61NPN-230V, radio actor universal dimming switch

Universal dim switch

Universal dimming switch, power MOSFET up to 300W. Automatic lamp recognition. Stand-by loss only 0.7 watts. Minimum brightness or dimming speed adjustable. With children's room, slumber and light-wake. In addition to light-rate control. Encrypted radio, bidirectional radio and repeater function can be switched on. For installation. 45mm long, 45mm wide, 33mm deep. Universal dimming switch for lamps up to 300W, depending on the ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps ESL additional depending on the lamp electronics and the dimtype. Zero-pass circuit with soft-on and soft-off for lamp protection. Supply, switching and control voltage local 230V. No minimum load required. The set brightness level remains stored when switching off (memory). In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. Automatic electronic overload protection and overtemperature shutdown. Encrypted sensors can be learned. It can be switched on bidirectional radio and / or a repeater function. Each state change as well as received central control telegrams are then confirmed with a radio telegram. This radio telegram can be learned into other actuators such as FSR61NP-230V, controllers and in universal displays. The current dimming value in% is also displayed in the respective app. With the upper% lamp / dim speed switch, either the minimum brightness (fully dimmed) or the dimming speed can be set. The lower switch determines in operation whether the automatic lamp detection should work or special comfort positions: AUTO allows the dimming of all lamp types. LC1 is a comfort position for dimmable 230V LED lamps, which cannot be dimmed to AUTO (phase section) due to the design and therefore must be forced to phase-cut. LC2 and LC3 are comfort positions for dimmable 230V LED lamps like LC1, but with other dimm curves. EC1 is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to the design, so that they can be switched on in a cold and safe way. EC2 is a comfort position for energy-saving lamps, which cannot be switched on again in accordance with the design. So memory is turned off in this position. The positions LC1, LC2, LC3, EC1 and EC2 shall not use inductive (wrapped) transformer. In addition, the maximum number of dimmable LED lamps may be lower due to construction than in the position AUTO. The buttons can be learned either as a direction button or as a universal button: As a direction button, turn on and dim on one side and turn off and dim on the other side. Double-click on the on-turn side triggers automatic dimming up to full brightness at dim speed. A double click on the switch-off side triggers the slumber. The children's room is installed on the on-board side. As a universal key, the direction is reversed by short release of the button. Light-level control, light-wake-up, child-room control and slumming according to the instructions. The LED accompanies the learning process according to the operating instructions and displays radio control commands in operation by a short flash.