FTN61NP -230V, radio actor Stair light follow-on switch, 1 close 10A

Radio actor Stairlight follow-up switch, 1 close 10A

1 close not potential-free 10A / 250V AC, 230V LED lamps up to 400W, light bulbs 2000 Watt. Reverse delay with switch-off warning and button-long light can be switched on. Encrypted radio, bidirectional radio and repeater function can be switched on. Stand-by loss only 0.8 watts. For installation. 45mm long, 45mm wide, 33mm deep. Supply, switching and control voltage local 230V. Contact in the zero passage to protect contacts and consumers. This radio actor as a stairlight follow-up switch has the most modern hybrid technology we have developed: We have combined the wear-free reception and evaluation electronics with a bistabile relay that switches through zero. As a result, there is no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. In addition to the radio control input via an internal antenna, this stairlight follow-up switch can also be controlled locally with a conventional 230V control button that may be installed before. Mica flow rate up to 5mA, depending on the ignition voltage of the mica lamps. After a power failure, the lighting is switched on again if the time course has not yet been completed. Encrypted sensors can be learned. It can be switched on bidirectional radio and / or a repeater function. Each state change and received central control telegrams are confirmed with a radio telegram. This radio telegram can be learned into other actuators, controllers and universal displays. With the upper turn switch, up to 35 radio-planets and / or motion-brightness sensors FBH are assigned in the position LRN, one or more central control buttons. This will then select the desired function of this stairlight follow-up switch. To find the desired position safely, the light-up of the light-emitting diode will help as soon as a new setting area has been reached when turning the switch. NLZ = follow-up switch. TLZ = Stair light time switch. + TLZ with TLZ with TLZ. + Deposition warning = TLZ with off-turn warning. + button-long light and switch-off warning = TLZ with button-long light and switch-off warning. In the case of the switch-on light, keys can be placed for more than 1 second on permanent light, which is automatically switched off after 60 minutes or can be switched off with buttons for more than 2 seconds. With the switch-off warning the lighting flashes approx. 30 seconds before the time run and a total of 3 times at shorter intervals. If the switch-off warning and the switch-off light are switched on, the switch-off warning shall be carried out after the switch-off of the continuous light. The lower turn switch will set the return delay from 1 to 20 minutes. If motion-brightness sensors FBH are learned, the switch shaft is set at the last time the FBH has been trained, in which the lighting switches on or off, depending on the brightness. The return delay to the FTN61NP is extended by the time set in the FBH of 1 minute. The LED accompanies the learning process according to the operating instructions and displays radio control commands in operation by a short flash.