MFZ12DX-UC, analog multifunction time relay, 1 changer 10A

Analog multifunction time relay, 1 changer 10A

1 changer potential free 10A / 250V AC, 230V LED lamps up to 200W, light bulbs 2000W *. Stand-by loss only 0,02-0,6 watts. Line installation device for assembly on DIN-EN 60715 TH35. 1 unit of division = 18mm wide, 58mm deep. With the patented ELTAKO- Duplex technology (DX), the normally potential-free contacts can still switch 50Hz in the zero pass when switching 230V AC voltage and thus drastically reduce wear. For this purpose, simply connect the N- conductor to the terminal (N) and L to 15 (L). This results in an additional standby loss of only 0.1 watts. Universal control voltage 12.. 230V UC. Supply voltage like the control voltage. Times between 0.1 seconds and 40 hours are adjustable. By using a bistabile relay, there is also no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. Depending on the connection of the power supply to the terminals B1-A2 or B2-A2, two different function levels can be selected. Functions F when connecting the power supply to B1-A2: (stand-by loss 0,02-0,4? W) RV = drop-back delay. AV = response delay. TI = Tact switch started with impulse. TP = clock set starting with pause. IA = pulse-controlled response delay (e.g. automatic door opener). EW = wiper. AW = off wiper. ARV = response and relapse delay. ON = Duration A. OFF = duration OFF. Functions (F) when the power supply is connected to B2-A2 (stand-by-loss 0,02-0,6W): SRV = current shock switch with relapse delay. ER = Relays. EAW = switch on and off wiper. ES = power shock switch. IF = Impulse. ARV + = additive response and relapse delay. ESV = current shock switch with return delay and off warning. AV + = additive response delay. ON = Duration A. OFF = duration OFF. The light-emitting diode under the large switch informs about the contact position during the time run. It blinks as long as the working contact is 15-18 (15-16 closed) and lights up constantly, while the working contact is 15-18 (15-16 open). The time base T is set with the middle-speed turning switch T. The basic values are 0.1 seconds, 0.5 seconds, 2 seconds, 5 seconds, 1 minute, 2 minutes, 5 minutes, 1 hour, 2 hours and 4 hours. The total time is the time base multiplied by the multiplier. The xT multiplier is set with the upper raving switch xT and is between 1 and 10. Thus, times between 0.1 second (time base 0.1 second and multiplier 1) and 40 hours (time base 4 hours and multiplier 10) can be set. * The maximum load can be used from a time of 5 minutes. In shorter times, the maximum load is reduced as follows: up to 2 seconds to 15?%, up to 2 minutes to 30?%, up to 5 minutes to 60?%.