EGS61Z-230V, power shock group switch, 1 + 1 close 10A

Power shock group switch, 1 + 1 close 10A

Power shock group switch for central control, 1 + 1 close not potential-free 10A / 250V AC, for a 230V AC engine. Stand-by loss only 0.4 watts. For installation. 45mm long, 45mm wide, 32mm deep. The most modern hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. This power-shock group switch transforms the commands of the sensor relays or switches and buttons and switches a 230V engine for a shading element or a roller shop. Control, supply and switching voltage 230V. A1, A7 and A8 must be controlled with the same potential as L. Due to the use of bistabiler relays, there is no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. With the control input A1, a universal button is used to control, stop, stop, stop. A direction button for off can be connected via the diode RTD (any polation). Another direction button for on will be connected directly to A1. At the first control pulse the EGS61Z switches the control input A1 to the direction button. In order to switch the control input A1 back to universal button, the supply voltage must be switched away for a short time. The additional control inputs A7 and A8 are controlled centrally on and centrally off with priority. With priority because these tax inputs cannot be overcontrolled by other tax inputs as long as the central tax contact is closed. With a control signal the switching position is activated on or off. Another control signal (< 700ms) at this control input immediately interrupts the process, and another control signal (> 700ms) continues to execute the current action. The RV is used to set the return delay. If the current shock group switch is in or off position, the set delay time is running, at the end of which the device automatically switches to stop. The delay time must therefore be chosen at least as long as the shading element or the roller shop is required to get from one end position to the other. The turn switch WA is used to control the turning automatic: In the setting between 0.5 and 2 seconds the turning time is switched on. In this case, only at the end of the delay time set with the upper switch, a reversal of the direction is made, for example, to clamp the awnings or to place blinds in a specific position. AUTO 1: No automatic turning and no comfort-turning function. A7, A8 and direction: operation < 1s - static process (contact closes only during operation) operation > 1s - dynamic process (contact remains closed), stop with new operation. AUTO 2: Automatic turning with 1? s turning time. In addition, the local comfort function for blinds with universal button on A1 is active: A double pulse causes slow turning into the opposite direction, which is stopped with another pulse.