SDS12 / 1-10V, 1-10V control dim switch for EVG, 1 close 600VA

1-10V control-dimming switch for EVG, 1 close 600VA

1 Clasp not free of potential 600VA and 1-10V control output 40mA. Stand-by loss only 0.5 watts. Minimum brightness and dimming speed adjustable. With children's room and slumber. Line installation device for assembly on DIN-EN 60715 TH35. 1 unit of division = 18mm wide, 58mm deep. Zero-pass circuit for contact protection. Also for controlling LED converters with a passive 1-10V interface without auxiliary voltage up to 0.6mA. On it with auxiliary voltage. Universal control voltage 8.. 230V UC, local and central on / off with the same potential. Supply voltage 230V galvanically separated. The latest hybrid technology combines the advantages of wear-free electronic control with high performance of special relays. The set brightness level remains stored when switching off (memory). In the case of a power failure, the switching position and the brightness level are stored and, if necessary, the power voltage is switched on when the power supply is returned. With the upper% lamp switch, the minimum brightness (fully dimmed) can be set. At the same time, it is determined whether the children's room and the slumber room are active (+ KI + SL). The dimspeed can be adjusted with the lower dimspeed switch. The load is switched on and off with a bistabile relay at the output EVG. Switching power fluorescent or NV halogen lamps with EVG 600VA. By using a bistabile relay, there is also no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. You can either connect direction keys to the upper / lower arrow, or these connection clamps are braked and a universal button is connected. As a direction button, turn on and dim on the top arrow and turn off and dim the bottom arrow. A double-click arrow above triggers automatic dimming up to full brightness at dim speed speed. A double click of the arrow below triggers the slumber. The children's room shading is executed with the button at the top of the arrow. As a universal key, the direction is reversed by short release of the button. Children's room control CI (universal or direction button arrow above): When switching on with a longer button operation, after ca.1 second is switched on with the smallest brightness and, as long as the button continues, slowly dimmed up without changing the last saved brightness level. Smurfshaltung SL (universal or direction button arrow below): By means of a double pulse, the lighting is dimmed and switched off from the current dimming position to the minimum brightness. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. Short keys can be switched off at any time during the dipping process. A long key dims high during the dipping process and ends the slumber.