SDS61 / 1-10V, 1-10V control dim switch for EVG, 1 close 600VA

1-10V control-dimming switch for EVG, 1 close 600VA

1 Clasp not free of potential 600VA and 1-10V control output 40mA. Stand-by loss only 0.5 watts. Dim speed adjustable. With children's room and slumber. With button or switch control. For installation. 45mm long, 45mm wide, 33mm deep. Circuit in the zero passage for contact protection. Also for controlling LED converters with a passive 1-10V interface without auxiliary voltage up to 0.6mA. On it with auxiliary voltage. Switching and control voltage 230V. The latest hybrid technology combines the advantages of wear-free electronic control with high performance of special relays. The load is switched on and off with a bistabile relay at the output EVG. Switching power fluorescent or NV halogen lamps with EVG 600VA. By using a bistabile relay, there is also no coil loss and no heating. After installation, wait for the automatic short synchronization before the switched consumer is placed on the net. Short control commands turn on / off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the direction of dimming. The set brightness level remains stored when switching off. In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. The dim speed switch (only when the button is used) can be used to set the dimming speed. In the event that light switch cannot be replaced by light button, the switch can be placed on the switch symbol at the right hand side: If the closed switch is opened again for a short time, then it is dimmed until it is opened again for a short time. A change of the direction of the dimming is made automatically at the two main points. In addition, the direction can be changed by opening the switch twice for a short time. With children's room control (only when using a button): When switching on with a longer button operation, after ca.1 second is switched on with the smallest brightness and, as long as the button continues, slowly dimmed up without changing the last saved brightness level. With slumbering (only when using a button): By means of a double pulse, the lighting is dimmed and switched off from the current dimming position to the minimum brightness. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. Short keys can be switched off at any time during the dipping process. A long key dims high during the dipping process and ends the slumber.