Fud71-230V, radio actor universal dimming switch up to 400W

Additionally available packaging sizes: 1 / 5

Universal dimming switch, power MOSFET up to 400W. Automatic lamp recognition. Minimum brightness and dimming speed adjustable. With children's room, slumber and light-wake, as well as constant light control and master slave operation. In addition to the light scene, you can control it via PC or with the radio. Encrypted radio, bidirectional radio and repeater function can be switched on. Stand-by loss only 0.7 watts. Assembly into the 230V power supply line, for example in intermediate ceilings and lamps. 166mm long, 46mm wide and 31mm high. With cable train load. Universal dimming switch for lamps up to 400W, depending on the ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps ESL additional depending on the lamp electronics and the dimtype. Zero-pass circuit with soft-on and soft-off for lamp protection. The set brightness level remains stored when switching off (memory). In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. Automatic electronic overload protection and overtemperature shutdown. Encrypted sensors can be learned. Bidirectional radio and / or a repeater function can be switched on. Each state change as well as received central control telegrams are then confirmed with a radio telegram. This radio telegram can be learned into other actuators and controllers. The current dimming value is also shown in%. The upper switch determines in operation whether the automatic lamp detection should work or special comfort positions: AUTO allows the dimming of all lamp types. LC1 is a comfort position for dimmable 230V LED lamps, which can not be dimmed sufficiently on AUTO (phase section) construction and therefore must be forced on phase cut. LC2 and LC3 are comfort positions for dimmable 230V LED lamps like LC1, but with other dimm curves. EC1 is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to the design, so that they can be switched on in a cold and safe way. EC2 is a comfort position for energy-saving lamps, which cannot be switched on again in accordance with the design. So memory is turned off in this position. In positions LC1, LC2, LC3, EC1 and EC2, no inductive (wrapped) transformer shall be used. In addition, the maximum number of dimmable LED lamps may be lower due to construction than in the position AUTO. LC4, LC5 and LC6 are comfort positions for LED lamps like AUTO, but with other dimm curves. PCT is a position for special functions set up with PCT14. The PCT14 connection is done with the DAT71 data adapter. With the average% lamp switch, the minimum brightness (fully dimmed) can be set. The dimspeed can be adjusted with the lower dimspeed switch. The buttons can be learned either as a direction button or as a universal button: As a direction button, turn on and dim on one side and turn off and dim on the other side. Double-click on the on-turn side triggers automatic dimming up to full brightness at dim speed. A double click on the switch-off side triggers the slumber. The children's room is installed on the on-board side. As a universal key, the direction is reversed by short release of the button. Light-level control, constant-light control, master-slave operation, light-wake-up, child room control and slumming according to the instructions. A step light switch function can be accessed with RV = 2 minutes after the switch with a button. With individual light-chain keys, selected brightness can be accessed when learning. A insulation switch can be realized with a trained FHD60. With up to 4 FBH, motion and brightness can be switched on. The LED accompanies the learning process according to the operating instructions and displays control commands in operation by a short flash.