FSR14SSR, RS485-Bus-Actor 2-channel current shock-free control relays

Additionally available packaging sizes: 1 / 10 / 100

Power shock control relays with 2 channels, 230V LED lamps up to 400W, light bulbs 400W. 2 solid state relays not potential-free. Bidirectional. Stand-by loss only 0.1 watts. Line installation device for assembly on DIN-EN 60715 TH35. 1 unit of division = 18mm wide, 58mm deep. Connection to the ELTAKO- RS485- bus. Cross-wiring bus and power supply with plug-in bridge. If both relays of the FSR14 are switched on, 0.4W is required. The rated power of 400W is valid for a contact and also as a sum of both contacts. The parallel connection of several devices to increase power is permitted. From the production week 12 / 17 with automatic electronic overtemperature shutdown. For a load < 1W, a GLE must be switched parallel to the load. In case of failure of the supply voltage is defined off. The channels can be learned independently as an ES- and / or an-channel. Scene control: With one of the four control signals of a double-tailed button, several channels of one or more FSR14SSR can be switched on or off to one scene. Central commands can be sent with radio keys and / or with a controller. The rotary switches are used to learn the buttons and, if necessary, test the 2 channels. For normal operation, the middle and lower switches are then set to AUTO. With the upper turn switch, the EW time (0- 120 seconds) for relays or RV time (0- 120 minutes) for current shock switches is adjusted for all channels. If radio motion brightness sensors FBH (Master) and / or FBH (Slave) are learned, the switching shaft is set with the upper switch, for each channel, at which the lighting switches on or off. The upper switch settings according to the operating instructions. If radio brightness sensors are learned, the switching shaft is defined with the upper switch, for each channel, in which the lighting switches on or off depending on the brightness (from about 0 lux in position 0 to about 50 lux in position 120). A hysteresis of about 300 lux between the on and off is fixed. An additional set of RV time is not observed. Only one FBH (Master) or FAH can be learned per channel. However, an FBH (Master) or FAH can be learned into several channels. If radio window door contacts FTK or window access sensor FFG7B are learned, different functions can be set with the average switch in positions AUTO 1 to AUTO 4 and can be connected to a maximum of 116 FTK: AUTO 1 = window to, then output is active. AUTO 2 = open window, then output active. In the positions AUTO 3 and AUTO 4, the FTK, which is used on a channel, are automatically linked. In the case of AUTO 3, all FTC must be closed to close the working contact (e.g. for climate control). In the case of AUTO 4, an open FTC is sufficient to close the working contact (e.g. for alarm or switch on the power supply of a wind outlet). One or more FTK can be learned into several channels so that different functions per FTK are possible at the same time. After a power failure, the connection is made by a new signal from the FTC or restored after 15 minutes at the next status message. An additional set of RV time is not observed. Function with radio smoke warning sensors FRW or water sensors according to the instructions. The LED under the upper switch accompanies the learning process according to the operating instructions and displays control commands in operation by a short flash.