FTN14, RS485- Bus-Actor Stair-light follow-on switch

Additionally available packaging sizes: 1 / 10 / 100

Stair light follow-up switch, 1 closing non-potential-free 16A / 250V AC, 230V LED lamps up to 400W, filament lamps up to 2000W, return delay with off-turn warning and button-long light can be switched on. Also for energy-saving lamps ESL up to 200 Watt. Bidirectional. Stand-by loss only 0.2 watts. Line installation device for assembly on DIN-EN 60715 TH35. 1 unit of division = 18mm wide, 58mm deep. Connection to the ELTAKO- RS485- bus. Cross-wiring bus and power supply with plug-in bridge. Gear voltage 230V. Contact in the zero passage to protect contacts and consumers. In the event of a failure of the supply voltage, the switching state is maintained. In the case of a recurring supply voltage, the time sequence at the end of which is switched off begins. In addition to the bus control input, this stairlight follow-up switch can also be controlled locally with a conventional 230V control button. Mica flow rate up to 5mA, depending on the ignition voltage of the mica lamps. The upper turn switch LRN is required for learning. After that, the return delay is set here for 1 to 30 minutes. With the average turning switch, the LRN is used to learn the function star and / or radio motion brightness sensors FBH, one or more central control buttons. The desired function of this stairlight follow-up switch is then selected: NLZ = follow-up switch with adjustable response delay. TLZ = Stair light time switch. ESL = Stair light time switch for energy-saving lamps ESL. + Taster-long light = with TLZ only. + off warning = with off warning (TLZ + ESL). + button-long light and switch-off warning = with button-long light and switch-off warning (TLZ + ESL). In the case of the switch-on light, keys can be placed for more than 1 second on permanent light, which is automatically switched off after 60 minutes or can be switched off with buttons for more than 2 seconds. With the switch-off warning the lighting flashes approx. 30 seconds before the time run and a total of 3 times at shorter intervals. If the switch-off warning and the switch-off light are switched on, the switch-off warning shall be carried out after the switch-off of the continuous light. With the lower switch, a response delay (AV- time) can be set at NLZ, when the switch is connected. position AUTO1 = 1s, AUTO2 = 30s, AUTO3 = 60s, AUTO4 = 90s and AUTO5 = 120s (legal strike). In addition, it can be manually set to permanent light. If the NLZ is controlled with a button, then the first key is switched on, only the second key starts the time sequence at the end of which is switched off. If radio motion brightness sensors FBH are learned, the switch shaft is set at the last FBH, at which the lighting is switched off or switched on depending on the brightness of the motion detection. The return delay to the FTN14 is extended by the time set in the FBH of 1 minute. If radio window door contacts are learned, either an opener or a closing is learned. Accordingly, the time sequence begins with the opening or closing of the window or door. If switches are learned for continuous operation, e.g. with radio transmission modules or FTS14EM, then the time is switched on when pressing and the time is only started when letting go. The LED under the upper switch accompanies the learning process according to the operating instructions and displays control commands in operation by a short flash.