Fud14 / 800W, RS485bus universal dimming switch up to 800W

Additionally available packaging sizes: 1 / 24

Universal dimming switch, power MOSFET up to 800W. Automatic lamp recognition. Stand-by loss only 0.3 watts. Minimum brightness and dimming speed adjustable. With children's room, slumber and light-wake. In addition with light-rate control and constant light control. Line installation device for assembly on DIN-EN 60715 TH35. 2 units = 36mm wide, 58mm deep. The delivery includes a distance DS14, 2 short connectors 1 TE (up to 400W load) and 1 long plug 1.5 TE (from 400W load with DS14). Universal dimming switch for lamps up to 800W, depending on the ventilation conditions, dimmable 230V LED lamps and dimmable energy-saving lamps ESL additionally dependent on the lamp electronics and the dimming type. Up to 3600W with power added FLUD14 on the X1 and X2 connections. The circuit is zero-pass with soft-on and soft-off for lamp-saving. Gear voltage 230V. No minimum load required. The set brightness level remains stored when switching off (memory). In the case of a power failure, the switching position and the brightness level are stored and will be switched on when the supply voltage is returned. Automatic electronic overload protection and overtemperature shutdown. Connection to the ELTAKO- RS485- bus. Cross-wiring bus and power supply with plug-in bridge. The upper turn switch LA / LRN is first needed for learning and in operation determines whether the automatic lamp detection should work or special comfort positions: AUTO allows the dimming of all lamp types. LC1 is a comfort position for dimmable 230V LED lamps, which cannot be dimmed to AUTO (phase section) due to the design and therefore must be forced to phase-cut. LC2 and LC3 are comfort positions for dimmable 230V LED lamps like LC1, but with other dimm curves. LC4, LC5 and LC6 are comfort positions for LED lamps like AUTO, but with other dimm curves. EC1 is a comfort position for energy-saving lamps, which must be switched on with an increased voltage due to the design, so that they can be switched on in a cold and safe way. EC2 is a comfort position for energy-saving lamps, which cannot be switched on again in accordance with the design. So memory is turned off in this position. In positions LC1, LC2, LC3, EC1 and EC2, no inductive (wrapped) transformer shall be used. In addition, the maximum number of dimmable LED lamps may be lower due to construction than in the position AUTO. PCT is a position for special functions that are set up with PCT14. With the average% lamp switch, the minimum brightness (fully dimmed) can be set. The dimspeed can be adjusted with the lower dimspeed switch. The buttons can be learned either as a direction button or as a universal button: As a direction button, turn on and dim on one side and turn off and dim on the other side. Double-click on the on-turn side triggers automatic dimming up to full brightness at dim speed. A double click on the switch-off side triggers the slumber. The children's room is installed on the on-board side. As a universal key, the direction is reversed by short release of the button. Light-level control, constant-light control, light-wake-up, child-room control and slumming according to the instructions. A step light switch function can be accessed with RV = 2 minutes after the switch with a push-in button. With individual light-chain keys, selected brightness can be accessed when learning. A insulation switch can be realized with a trained FHD60. With up to 4 FBH, motion and brightness can be switched on. The LED accompanies the learning process according to the operating instructions and displays control commands in operation by a short flash.