F4T65-wg, in E-design in pure white shiny, battery and conductive, with double taps

Additionally available packaging sizes: 1 / 10

Radio-4-channel-button, pure-white, shiny for single assembly 84x84x16mm or assembly into the E-design switch system. Creates the energy for radio telegrams even at key pressure, therefore without connection line and no stand-by loss. With a double. Smart Home Sensor. The scope of delivery includes the frame R1E, a sieve, a double sieve, a mounting frame, a holding plate, the radio module and a adhesive film. Funktaster with a tilt can send two evaluable signals: press the top of the tilt and press the bottom of the tilt. Funktaster with double-face can send four evaluable signals: press two heads at the top and at the bottom. The support plate can be screwed to a flat surface or glued to the wall, glass or furniture with the attached adhesive foil. The sleeves in the can are used for screw fixing via a 55mm switch box. From the factory, the double-face has been mounted on the radio module. If this is to be replaced against the large sieve, then pull the sieve halves forward and do not bend to the middle. After that, the large sieve is so fast that its markings 0 and I on the back match the radio module. When gluing, first attach the set of support plate with frame and mounting frame with the top and bottom ramps. Then the set of radio module with a sieve - marking 0 on the back always fasten up. Before screwing, remove the frame from the support plate with the mounting frame. To do this, press the support plate to the outside. Then screw the support plate - with the top and bottom ramps - and the frame with the mounting frame, and the set of radio module with a tilt - marking 0 on the back always at the top. The radio module contained in the radio monitor can be learned in an encrypted manner according to the operating instructions in all the encrypted actuators of the series 61 and 71, as well as in the FAM14.