FTDI Chip UART USB A Male to Female Converter Cable

FTDI Chip USB To MPSSE Cable

The FTDI Chip 500mm USB to MPSSE cable contains a small internal electronic circuit board, utilising the FTDI FT232H. It is encapsulated into the USB connector at the end of the cable to handle all the USB signalling and protocols. The cable provides a fast and simple way to connect devices with 3.3VDC digital interfaces to the USB. The integrated FT232H device incorporates a command processor called the Multi-Protocol Synchronous Serial Engine (MPSSE). The purpose of the MPSSE command processor is to communicate with devices that use synchronous protocols (such as JTAG, SPI, or I2C) efficiently. The cable is terminated by ten individual wires with single pole connectors that can be interfaced to a male header.

The FTDI Chip 500mm USB to MPSSE cable contains a small internal electronic circuit board, utilising the FTDI FT232H. It is encapsulated into the USB connector at the end of the cable to handle all the USB signalling and protocols. The cable provides a fast and simple way to connect devices with 3.3VDC digital interfaces to the USB. The integrated FT232H device incorporates a command processor called the Multi-Protocol Synchronous Serial Engine (MPSSE). The purpose of the MPSSE command processor is to communicate with devices that use synchronous protocols (such as JTAG, SPI, or I2C) efficiently. The cable is terminated by ten individual wires with single pole connectors that can be interfaced to a male header.

Features and Benefits

Connector A is male USBConnector B is female receptacleUSB 2.0 Hi-speed (480Mbps) and full speed (12Mbps) compatibleMaximum output current rating is 250mA at 3.3VDC on VCC1kB receive and transmit buffers for high data throughputAdjustable receive buffer timeoutEntire USB protocol handled on the chip – No USB-specific firmware programming requiredFully assisted hardware or X-ON/ X-OFF software handshakingLow operating and USB suspend current low USB bandwidth consumptionSupport for USB suspend and resumeSynchronous serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI, and I²CTransmit and receive LED drive signalsUHCI/ OHCI/ EHCI host controller compatibleUSB bus poweredUSB type A connector for direct connection to a host or hubOperating temperature ranges between -40 and 85°C

Connector A is male USBConnector B is female receptacleUSB 2.0 Hi-speed (480Mbps) and full speed (12Mbps) compatibleMaximum output current rating is 250mA at 3.3VDC on VCC1kB receive and transmit buffers for high data throughputAdjustable receive buffer timeoutEntire USB protocol handled on the chip – No USB-specific firmware programming requiredFully assisted hardware or X-ON/ X-OFF software handshakingLow operating and USB suspend current low USB bandwidth consumptionSupport for USB suspend and resumeSynchronous serial (MPSSE) data rates of up to 30Mbps on JTAG, SPI, and I²CTransmit and receive LED drive signalsUHCI/ OHCI/ EHCI host controller compatibleUSB bus poweredUSB type A connector for direct connection to a host or hubOperating temperature ranges between -40 and 85°C

Applications

Automation systemsElectronic devices

Automation systemsElectronic devices

Certifications

ANSI/ESD S20.20:2014BS EN 61340-5-1:2007FCC certifiedCE certifiedUL2464 approved

ANSI/ESD S20.20:2014BS EN 61340-5-1:2007FCC certifiedCE certifiedUL2464 approved